How to sew a dress without a pattern?

If there is any doubt that having armed only with sewing tools and having made several measurements, you can sew the original dress, throw them aside. This article provides different models of dresses, stitched without a pattern, which can not be distinguished from the factory.

Light and airy chiffon is a real salvation in hot weather, and it looks elegant and romantic, fluttering in the wind. A good example would be a short short front dress in the back, which we will sew.

Take a T-shirt and circle it, not forgetting the seam allowances. Immediately on the fabric, model the neckline of the front neck, making it deeper or more closed, asymmetric, or gang.

There are no Taliyev tucks, but if you wish you can make tucks on the chest. Then on the front of the neckline cut the armhole increase by a couple of centimeters.

From the armhole line on the back of the dress make flare in the form of a trapeze and decorate the neckline of the skirt. To do this, mark the length of the skirt in the middle of the back, for example, 130 cm, then smooth the hem to the side seams with a smooth line. On the front skirt also flare and measure the desired length, then decorate the neckline hem.

If you like models that are short in front and long in the back with a smell on the skirt, then the skirt is cut out separately and then sewn to the top. The finished bodice can be a bodice or sewn independently. Just do not forget about the clasp, if the top is tight-fitting and sewn from a poorly stretching fabric.

If the fabric is transparent, sew an additional short petticoat or bypassing the shirt, lengthen the top of the fabric.

Sewing skirts:

1. Rectangle width not less than 140 cm and the desired length for the skirt, fold in half.
2. Measure 10–12 cm on the opposite side of the fold for odor.
3. Down set aside the length of the front skirt with hem allowances.
4. Draw a diagonal line from the corner point through the length point of the front skirt to the bottom, smoothly rounding the hem.

On the skirt, treat the bottom with an overlock or use the snail's foot, and sew an elastic at the top. Sew together the skirt and top.

Linen fabric with stripes and a loose sundress with a detachable bodice and a half-sun skirt with a frill will give comfort in the warm season.

For the top, you will need 2 rectangles with a width equal to the chest half-grip and the length of the shelf measure, additionally add allowances. Also measure the height of the armhole and set aside on the segments.

Make oblique lines making the armhole, then make the drawstring at the top, process the armholes and sew both halves of the bodice. Thread the tape.

Cut out the skirt:

1. 150 cm wide fabric fold in half.
2. Measure the waist, or rather the place where the top of the dress ends.
3. Half of the measurements with allowance set aside in the corner of the segment in a semicircle.
4. Measure the length of the skirt without flounce around the canvas.
5. Cut out the part and sew.

From the remaining fabric, open a rectangle for the shuttlecock. Gather it and stitch it to the skirt, then stitch off the skirt and top of the sundress.

It's hard to believe, but a dress for a cocktail party or for a date can be stitched by paving a single line. In appearance, it will be no worse than the designer’s one, and you will spend only 10 min.

You will need a piece of knitted fabric with the addition of viscose 150x150 cm.

1. Fold it in half.
2. Measure your chest and thighs. Measure the half-grip of the larger measure at the bottom of the fabric and draw a line up without reaching the edge by 25 cm.
3. Now lay a line along the marked line and two more at a distance of 1 cm. To prevent the machine from pulling the fabric, place a sheet of paper under the bottom and then carefully remove it from the seam.

Stretch a long satin ribbon to the received 2 curtains. The dress is ready.

Since the viscose does not rattle and the arrows do not go, there is no need to process the edges.

Try on a new outfit, fasten the shoulder sections with a beautiful pin or brooch, you can sew them, now adjust the length and form a drape.

A simple cut knitted dress on the straps will provide comfort while doing household chores, and at the same time will allow you to look beautiful.

Open 2 rectangles with a width equal to the half-length of the chest with seam allowances, if you want a tight fit, and the length you need. For example 55x65 cm.

The next step is to design the armhole and round the hem:

• Fold the pieces in half.
• In the lower corner of the opposite bend, measure 10 cm and 3 cm up, then connect the dots with a semicircular line.
• Measure 5.5 cm in the top corner and 11 cm to the left.
• In the opposite corner on the fold, measure 1 cm from the upper cut at the back and 3 cm at the front. And smoothly connect the top points.

Process the upper and lower sections with a bake of the remaining fabric. In the upper stretch gum. If the dress is loose, sew a elastic on the waist.

It remains to make the straps, which will serve as a bake for armholes. Open the strips with a length of 25 cm. Attach them along the side cut to the armhole in front and to the armhole of the backrest. Make a hem on the second side cut, ironing it. And then sew on the reverse side of the details. Stitch the details on the sides.

Expectant mothers need to stay stylish during pregnancy, without causing discomfort to themselves and the baby. One of the successful styles for pregnant women is a loose simple dress that can be decorated with beads, lace, detachable collars or bright brooches.

For sewing a free dress for pregnant women, only one measure is needed - the volume of the hips. If the tummy is already large, then the volume of the abdomen.

• From a wool or any dense fabric, open a rectangle 130 cm wide and 160 cm long.
• Fold the piece 4 times.
• From the bend, measure the timbers of the waist or hips and plus 5 cm.
• From the resulting point set aside up to 40 cm.
• For the sleeve, set aside 30 cm from the opposite side and connect the two points obtained by a line, slightly rounding the corner.
• Cut parts along the line, and then cut the neck.
• Do a one-piece trim of the neck and stitch it.
• Sew the side seams and trim the bottom of the dress.
• On the sleeves make a drawstring and stretch the elastic in it.

This style has long been loved and firmly entrenched in fashion. How to sew it without a pattern, look at the video.